Better Results From Any
Carpet Cleaning Chemical System

The traditional method of carpet extraction is to put the cleaning chemical into the solution tank. But doing that gives the chemical just a fraction of a second to work. You’d get almost the same results with plain water!!

Here’s a better way -

1.  Using a pump-up sprayer, pre-spray an area you can clean within ten minutes with your carpet extractor. Do not allow the area to dry. Prespraying allows time for the chemical to work.

2.  Spot as needed. Prespraying forces the user to look harder at the floor, making spots stand out better.

3.  Extract with cool water and a neutralizer (to prevent browning and wicking) in the solution tank. Don't forget defoamer in the recovery tank - this method often removes lots of residual chemical from previous cleanings.

   We’ve seen great results with the products below,
but using this method will improve your results from any chemical system.
Give it a try!